p4newstreet logo

So to draw a line under the last post. The Lima CCT is finished off and ready for service.

So is the crane. It rides very high as supplied so I ground the bearing slots down and removed a bit of material from under the axleboxes (its still a smidge to high). Seems strange that Hornby raised the ride height on all their models to accommodate their tension lock coupling. Why not just make that smaller instead?

The end shackles are from Roxey and the cables are the heavier e-z line. Transfers are from Cambridge Custom Transfers. The single plank wagon is just standing in at the moment.

One of the issues with Brettell road is the height it sits at. The subject of layout height is a thorny one but I take the view that operator comfort trumps everything else. After all we will be working on the layout for a couple of days . Currently its a bit low which I’ve got round by asking show organisers to provide chairs. From a sitting position its just about the right height.

However I’ve been thinking of doing a more traditional style, separate roof and here it is mocked up. Its designed so that it all slots together and no screws or bolts will be required. It will still have a material roof to shield the ambient light but it should make the layout itself a little lighter too. The plan is for the original pelmet to be removed.

One Response

  1. Mervyn

    They’re great Jim, so removed from their origins. Must dig my crane out now and have a go at improving it.

    30/07/2019 at 7:15 am

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.