p4newstreet logo

Posts tagged “Bedford ML

More wagons

wooden-opensWhat you see above is a variation on a theme, both started out as Parkside kits for the same wagon (although different generations of the same kit) and both have been built to represent something slightly different to what was intended. On the Left a clasped brake version achieved by substituting the supplied chassis for a PA16 chassis kit from the same supplier. On the right the supplied chassis modified with vac cylinder and tie bars (0.7mm L section from Eileens).

steel-opensA selection of steel opens built pretty much as intended. The far left is a Red Panda kit the others are Parkside with the usual extra detailing. It’s good to see that the Red Panda kits have reappeared from Parkside although the example shown here remained available continuously.

abandoned-lorry-2I decided I quite likes the idea that when the building shown in the last update was abandoned an unfortunate lorry was left behind too. Perhaps it wouldn’t start or its been dumped there?  Having mooched around for a suitable victim I quite fancied a kit rather than ready to plonk and I havent built a vehicle kit for a while. I settled on a Coopercraft Bedford ML and set to work.

The kit is quite poor if i am honest. There’s loads of flash and the fit of the parts isn’t great. I also decided that the windscreens were far too small but being all plastic it’s not too much hassle to fashion something presentable and as I’ve mentioned before I find poor kits strangely rewarding. I attacked the bed with a circular saw in a mini drill to gouge out some of the planks and simlulate rot.  The above is the more presentable side!

abandoned-lorry-1On this side I cut off a wing and cut down the tires to simulate flats. The rubber at the bottom was added with filler. The lorry was first weathered with a light blue to simulate fading, varnished and then gouache was used for the rust. another coat of varnish and washes of enamels were added to simulate dirt and grime. Finally the whole thing was dry brushed with Klear to make it look wet.

On the subject of road vehicles I will be doing a demo at Scaleforum this month so please stop by for a chat if you are going.

http://www.scalefour.org/scaleforum/2015/